Made-to-Measure Marble Skirting Boards: A Practical Guide to Choosing and Fitting

Made-to-measure marble skirting boards are the detail that ties a stone floor together, protecting the base of the wall while giving the room a continuous, refined line. Compared with timber or PVC, natural stone skirting resists knocks, moisture and cleaning agents far better, never swells and never needs repainting. When the floor is already marble or granite, matching the skirting to the same material creates a visual coherence that no coated profile can replicate. It is the natural choice wherever durability and aesthetics have to work together.

Marble skirting vs timber and PVC

The right dimensions come from the room survey, not from habit. The most common heights range between 7 and 10 cm, with thicknesses around 1 to 2 cm, while lengths are cut to suit each wall to keep joints to a minimum. Measure every wall individually: older rooms are rarely perfectly square, and a careful survey avoids forcing pieces during fitting.

• Height: balance it against door architraves and the floor format.
• Thickness: thicker profiles suit grand spaces; slimmer ones keep contemporary interiors clean.
• Length: plan the cutting layout to position joints where they are least visible.

The top edge defines the character of the skirting. The most requested profiles are polished square edge, bevelled edge and bullnose (toro). A polished square edge gives a crisp, modern line; a bevel softens the transition and hides minor wall irregularities; a bullnose is ideal for classic settings. Match the finish and the stone to the floor: same material and surface treatment for a seamless look, or a deliberate contrast when you want the skirting to stand out.

Accurate measuring is what makes made-to-measure marble skirting boards worthwhile. Measure wall by wall at floor level, note every internal and external corner, and mark obstacles such as radiators, pipes and door openings.

• Internal corners: butt the pieces squarely, or mitre them for a continuous line.
• External corners: mitre at 45° for the cleanest result.
• Joints: keep them minimal and consistent, leaving a controlled gap for sealing.
• Tolerances: allow a small expansion gap against the floor and never fit pieces under tension.

Correct preparation determines the final result. Work on a clean, dry, sound wall.

• Prepare the substrate: remove dust, old adhesive and loose plaster; the wall must be flat and dry.
• Dry-lay the pieces: position the skirting without adhesive to check cuts, corners and joint alignment.
• Bond with two-part adhesive: apply the two-part marble adhesive in measured points on the back of each piece, press into place and check the line with a spirit level.
• Seal the joints: fill joints and the floor junction with Kedisil N 310 silicone, choosing the colour variant that matches the stone for an almost invisible finish.
• Clean as you go: remove any excess adhesive or silicone before it cures.

A few recurring errors can spoil an otherwise good job:

• Cutting in place without a guide: freehand cuts produce uneven edges and open joints.
• Visible joints: poor layout and the wrong silicone colour make every junction obvious.
• Too much adhesive: excess two-part adhesive squeezes out, stains the stone and complicates levelling.

For everyday care, dust regularly and clean with products formulated for natural stone.

When you order made-to-measure marble skirting, supply a clear survey with heights, thicknesses, lengths and the position of every corner, along with your chosen edge profile. Pair it with the correct two-part adhesive, the matching Kedisil N 310 silicone and the right maintenance kit, and the result will be a precise, lasting finish. For dimensions and materials tailored to your project, request a custom quote.